Page 1 of 1

Weld Points (Subdivision op)

PostPosted: Tuesday, 17.September 2013, 12:42
by Skinnytorus
Imho a weld points option (with tolerance control) is needed in Subdivision op. Have you ever tried to subdivide a mirrored mesh? If you did, then you know what I'm talking about - mirror op doesn't weld points. Therefore, subdiv is applied to both parts of the mesh separately.

Re: Weld Points (Subdivision op)

PostPosted: Wednesday, 18.September 2013, 08:01
by Skinnytorus
Or maybe a separate op for point welding? That would be more universal in terms of use.